The F4V2/F4V3 differential expansion board connects directly to F4V2 or F4V3 without the need for a 40-pin ribbon cable.
The board has two RJ-45 connectors. Each connector can drive a.
The F8-Distro Board is an eight port power distribution board. The board has one 30amp power input connector and eight 5A connectors. The connectors are pluggable connectors for easy.
Shipping December 5th
Works with F16V4 only.
The F16V4 Expansion Board connects the F16V4.
Completely Assembled. This.
Shipping November 20th
- CG-1500 mounting Plate for F16V2/F16V3. The plate can be used to mount one of the following configurations to CG-1500 enclosure.
The new expansion boards has two 40-pin connectors.
The Differential Expansion Board connects the the F16V2 or F16V3 via 40-pin ribbon cable. Allows up to four receivers to be connected to.
The new expansion boards will have two connectors. (Not shown in image)
F16v2/F16V3 Expansion Board with ribbon cable
Completely Assembled. This board expands a.
Falcon F-Amp with xConnect Pigtails
The F-Amp with xConnect Pigtails include a male and female connector. Sealed epoxy for complete waterproof solution.
Falcon F-Amp with Ray Wu 13.5mm Pigtails
The F-Amp with Ray Wu 13.5mm Pigtails include a male and female connector. Sealed epoxy for complete waterproof solution.
The Falcon F-Amp is a line buffer designed to boost the data signal that controls 3-wire pixels. The F-Amp can be attached directly to the pixel controller or can be placed.
Eight pack of 3.5mm connectors. Fits F16V3, F4V3, F16V2R, F16V2 expansion boards and receivers.
Eight pack of 2-pin 3.5mm connectors. Fits F8 distro boards and power input for F48.
40-Pin Ribbon Cable. Works with F16V2/F16V3 Expansion Boards.